85 views
Most mistakes when installing a new radio have been made when assigning the cables. First, be sure which cable goes where. You should pay particular attention to the wires that are live. Largely the live cables are black and red. Red is the positive pole, it contributes to the battery to the car stereo. Black, on the other hand, is that the negative pole, it's returned from the radio. But beware! At times the negative pole cable can also be blue or brownish!
If everything works perfectly, you can install the auto radio completely. If you liked this posting and you would like to acquire far more facts concerning hilfe bei autoradios kindly stop by our site. If that is not the case, there is probably a wrong wiring. Insert the cables and test again. Tip: it's ideal to plan a radio channel. If this is no longer saved when you turn off the radio and on, likely something is wrong with the pin assignment. If the car radio is in the right location, attach the cover or the framework of the new automobile radio. Already you can listen to your favourite songs as you desire.
Small plug and cable customer. Each car radio has two kinds of connections: inputs and outputs. The inputs include, for example, the electricity supply. The outputs contain the connections for hilfe bei autoradios the speakers. If you aren't certain, you are able to attach small labels to the cables. The way to find your way about later. Incidentally, not all manufacturers use the same connectors. So as to have the ability to wire your new radio, you ought to get in this situation a pair of adapter plugs. Another point is the power source of this antenna amplifier.
Now connect the connections to the new radio. Generally, the connections just fit on one connection, so you ought have no difficulties. Then gently push the wires back into the compartment and slide the radio behind. Make sure to merely fit the radio about halfway, since you should do a little test at this point. Sometimes special tools are needed
To find the radio from this slot, you need special release hooks. These are usually included. If you don't have appropriate hooks on hand, it is also possible to ask a workshop to lend you the special terminals for a short moment. To unlock the radio, then slide the pins and into the slots / holes supplied.
For some radios this is achieved via the antenna output. If the new radio does not have it (so it is"passive"), then you may also use a special adapter plug here. However, then the radio reception is poorer. If you take care of those things beforehand, everything will probably be a lot easier to do afterwards.
Now carefully pull on the tool. The older car radio is currently slipping out of control. Gradually pull the radio out of the center console, taking extra care not to rip any plugs. Then disconnect all links from the radio. Don't destroy themas they will need the wires . Take now a flat screwdriver and remove the mounting framework of the older car radio in the tray. To do so, fold up all the metal tabs so that you can then eliminate the frame.